Click the image above for Video Presentation
April 29th, 2009
Understanding Batteries and the Battery Life Saver
The Battery Life Saver electronic device will extend the life of any lead-acid battery and can rejuvenate “dead” batteries to a like new condition. But how does it work? To understand... Read More
April 28th 2008
Battery recycling takes deadly toll in Africa
First, it took the animals. Goats fell silent and refused to stand up. Chickens died in handfuls, then en masse. Street dogs disappeared Read More
April 28th 2008
Battery Restoration, Part 1
Batteries are vital in our society, an upper level in the scale of ability for humankind. They give us the power to store and manipulate energy. They are everywhere from... Read More
Feb. 25th 2008
Is Biofuel Craze a Mirage?
In September 2007, Lewis Smith, Environment Reporter for Times Online, warned us that we may need to jump off the biofuel... Read More
An electronic device that brings dead batteries back to life, restores functioning batteries to new condition, and keeps batteries from losing capacity and life due to the main cause of battery failure: the buildup of lead sulfate. There are different models for different types of batteries.
Width: 4.5 inches
Height: 2 inches
Depth: 2.5 inches
Questions? Call Toll Free 1-866-301-8835
75% to 80% of lead acid batteries fail prematurely because of formation of lead sulfate on the plates. These crystals cause batteries to become unusable at approximately one-third of their natural life. The Battery Life Saver electronic device dissolves the lead sulfate crystals.
Using breakthrough square wave technology, The Battery Life Saver electronic device sends a frequency signal to each crystal of lead sulfate, causing it to dissolve into lead and sulfuric acid. This restores the battery to its original condition and allows the electrical charge to be drawn from the battery.
It makes old batteries as good as new. It keeps new batteries new, saving time and money. With The Battery Life Saver electronic device, more power is available from your battery and you need less power to charge it. By reducing the number of batteries that get thrown away and put in landfills, The Battery Life Saver electronic device protects the environment. To see the different models, click here.
• To restore a dead or barely usable battery, connect the Battery Life Saver electronic device to the battery, along with your battery charger. A 6 - 10 amp charger works best. The Battery Life Saver electronic device is powered by the battery and only two wires need to be connected, one to each terminal of the battery. Allow the battery to charge until the specific gravity reaches between 1.250 and 1.300. This would be equivalent to a new battery. If you don’t have a hydrometer to measure specific gravity, you can check the voltage while the battery charger is on. If the voltage is over 15 volts, the battery is fully rejuvenated. This process can take several days to as much as many weeks for a badly sulfated battery.
• To accelerate the de-sulfating process, turn the battery charger off if the battery voltage is at least 11.5 volts. Leave the Battery Life Saver electronic device connected and allow it to run by itself for 12 hours. Then turn the battery charger on and allow it to run for 12 hours or until fully charged (in some cases it can take as few as 6 to 10 hours) with the battery charger on. Do this alternately until the specific gravity is within range.
• To maintain working batteries, install the Battery Life Saver electronic device on each battery or on a bank of batteries. It rejuvenates the batteries while it is in service. This causes more power to be available from the battery and causes less power to be needed to charge the battery. This is the best way to extend the life of your batteries. It’s like having a brand new battery every time you use it.